Company Introduction
Our Factory
Development History
Company Culture
Our Certificates
AUTO RGB Amusement Light
Programmable RGB Amusement Light
RGB LED Floodlight
Single Color Amusement Light
E10 E14 Turbo Housing
Accessories
Application Area
Products Video
Enterprise News
Industry News
Please click on the upper right corner
Share it with your circle of friends
Aglare RGB floodlight with remote control procedure SE2 pairing video
After purchasing the RGB floodlight, users must complete a pairing process to link the remote control to the light. So, how do you connect a remote control to an RGB LED floodlight?
Before beginning the pairing process, it is critical to confirm the model of the remote control, as there are several different types of remote controls on the market, including crystal frequency and chips.
Aglare Lighting RGB Series LED Remote Control Flood Light
Once the model is determined, you can follow the steps below to pair:
1. First connect the RGB floodlight to the power supply, then find the button on the back of the RGB floodlight and press it for 5 seconds
2. Enter the pairing mode and the red light will light up
3. Press the button on the remote control and the light will flash once, indicating that the pairing is successful.
4. Press and hold the button again for 5 seconds to exit the code matching mode
5. Then you can use the controller to control the light
Here is the Aglare RGB floodlight with remote control procedure SE2 pairing video
https://www.youtube.com/embed/-bn5u5D8VYg
https://www.youtube.com/embed/-bn5u5D8VYg
Common problems and solutions for pairing the remote control with the RGB floodlight
1. The light does not flash or respond
• Check the power supply: Make sure the light is properly connected to the power supply and turned on.
• Check the remote control: Make sure the remote control has sufficient power and is not damaged.
• Retry pairing: Try to enter pairing mode again.
2. The remote control cannot control the light
• Check the frequency: Make sure the remote control and the light are using the same frequency.
• Clear interference: Make sure no other electronic devices are interfering with the signal.
• Reset the light: Reset the light according to the instructions in the user manual and then re-pair.
3. The light keeps flashing
• Check the pairing status: Make sure the light has been successfully paired and stopped flashing.
• Re-pair: If the light keeps flashing, try re-pairing.
Where is the Aglare RGB floodlight used?
Aglare RGB floodlight is very suitable for amusement parks, stages, parties, billboards, playgrounds, and landscapes due to its rich color changes and flexible control features.
